Perfect-aire PATCH10000 User Manual download pdf (Page 12)

INSTALLATION INSTRUCTIONS (CONTINUED)

Exhaust hose installation:

The exhaust hose and adaptor must be installed or removed

in accordance with the usage mode as indicated below.

1. Install the vent joint and flat mouth adaptor onto the exhaust

hose as shown in Fig. 16. Refer to the previous pages for

window kit installation.

2. Slide the exhaust hose into the air outlet opening in the direction

depicted by the arrow in Fig. 17.

Fig. 17

Fig. 19

Fig. 18

max 47.25 in (120 cm)

min 11.8 in (30 cm)

Fig. 16

COOL or AUTO mode Install Hose

Remove Hose

FAN, DRY, HEAT*

(*for units with electric heating function)

Vent

Joint

Flat Mouth

Adaptor

Exhaust

Hose

The duct can be compressed or extended moderately

according to the installation requirements, but it is

desirable to keep the duct length to a minimum.

IMPORTANT:

DO NOT OVER BEND THE DUCT. See Fig. 19.

NOTE: Wall ventilation accessories are not available for

this product.

Make sure that there is no obstacle around the air outlet of

the exhaust hose (in the range of 20 in (500 mm)) in order for

the exhaust system to work properly.

CAUTION:

Note: Flat mouth adaptor and vent joint must be threaded

counter clockwise onto the exhaust hose. Extend both ends of

the exhaust hose 1-2 inches before installing these pieces onto

the exhaust hose.

1 2 ... 7 8 9 10 11 12 13 14 15 16

No comments

Perfect-aire PATCH10000 User Manual Page 12